User manual

en
53
 Curtains, fabric
 Upholstery, cushions
 Cut pile carpets, rugs and run-
ners
 Energy-saving vacuuming. This
setting is also very quiet
 Loop pile carpet and rugs
 Hard flooring and heavily soiled
carpets and rugs
Depending on the model, your vacuum
cleaner will be fitted with the following
suction power selector:
Auto suction power is automat-
ically adjusted for the type
of floor being vacuumed
 Do not use the “Auto” setting to
vacuum lightweight materials or cur-
tains. These could be sucked in and
possibly damaged.
When using the adjustable floorhead,
if the suction seems too high, reduce
the suction until the floorhead is
easier to manoeuvre.
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following suction power se-
lectors.
– Footswitches
– Radio-control handle
Foot controls (dia. 22)
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
 Press the + foot control to select a
higher setting.
 Press the - foot control to select a
lower setting.
Radio-control handle (dia. 23)
When the vacuum cleaner is switched
on with the On/Off foot control , the
Standby indicator  on the vacuum
cleaner will light up yellow.
 Press the Standby button  on the
handle.
The Standby indicator  on the va-
cuum cleaner will go out.
The first time the vacuum cleaner is
switched on, the highest setting will be
selected automatically.
After that the vacuum cleaner will
switch on at the setting which was used
previously.
 Press the + button to select a higher
suction power level.
 Press the - button to select a lower
suction power level.