Manual

en
55
dustbags, 4 AirClean exhaust filters and
4 motor protection filters (available de-
pending on country).
Original Miele exhaust filters can also
be purchased separately from the Miele
Customer Service Department or your
Miele dealer. Please quote the model
number of your vacuum cleaner when
ordering to make sure you get the cor-
rect filter. You can also order these fil-
ters via the Miele webshop.
Airflow indicator(Fig. 37)
Change the dustbag when the colour
marker in the airflow indicator turns red,
or sooner if it is no longer effective (see
possible reasons for this below).
Miele dustbags are intended to be
used only once. Dispose of the dust-
bag when it is full. Do not attempt to
re-use. Blocked pores reduce the
suction power of the vacuum
cleaner.
To check the airflow indicator
 Attach the standard adjustable floor-
head to the vacuum cleaner.
 Switch the vacuum cleaner on and
select the highest power setting.
 Lift the floorhead off the floor a little.
How the airflow indicator works
The airflow indicator is set for normal
household dust. This generally contains
a mixture of dust, hair, threads, carpet
fluff, grit etc.
However, if the cleaner has been used
to vacuum up fine dust, such as plaster,
brick dust, cement or flour, the pores of
the dustbag will become blocked very
quickly.
This affects the air permeability of the
bag, and the marker will indicate that
the bag is “full” even when it is not. The
dustbag must be replaced if this is the
case.
If, on the other hand, a large amount of
hair and carpet fluff which typically con-
tains a lot of air is vacuumed up, the in-
dicator may fail to react even though
the bag is full. You should still change it.
Both these extremes can occur.
Remove the dustbag (Fig. 38)
 Press the release catches at the side
of the hose connector, and lift the
hose from the socket.
 Lift the release catch for the dust
compartment lid and raise the lid as
far as it will go (Fig. 09).
The dustbag has a flap which closes
automatically when the dust compart-
ment lid is raised to prevent any dust
escaping.
 Pull the dustbag out by the grip on
the collar.
Fitting a dustbag (Fig. 39)
 Fit the new dustbag into the holder as
far as it will go. Leave the dustbag
folded up when you take it out of the
box.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
A safety device prevents the lid clos-
ing without a dustbag in place. Do
not force it.