Manual

Problem solving guide

Many malfunctions and faults that can occur in daily operation can be easily

remedied. Time and money will be saved because a service call will not be

needed.

The following guide may help you to find the reason for a malfunction or a fault,

and to correct it.

Problem Cause and remedy

The vacuum cleaner

switches off automatic-

ally.

On certain models, the

overheating warning

light also comes on .

A temperature limiter switches the vacuum cleaner off

automatically if it gets too hot. This can occur if, for

instance, large articles block the suction tube or when

the dustbag is full or contains particles of fine dust. A

heavily soiled exhaust or dust compartment filter can

also be the cause of overheating.

 Switch the vacuum cleaner off immediately using

the On/Off foot control . Disconnect from the

electricity supply. Switch off at the wall socket and

unplug it.

After removing the cause, wait for approximately 20 -

30 minutes to allow the vacuum cleaner to cool down.

It can then be switched on again.

Technical data

(for models with radio controlled handle)

Frequency band 433.05 MHz – 434.79 MHz

Maximum transmitting power < 10 µW

Conformity declaration

Miele hereby declares that this vacuum cleaner complies with Directive 2014/53/

EU.

The complete text of the EU declaration of conformity is available from one of the

following internet addresses:

– Products, Download from www.miele.co.uk

– For service, information, operating instructions etc: go to www.miele.co.uk/do-

mestic/customer-information-385.htm and enter the name of the product or the

serial number