Operating and Installation instructions

Electrical connection
93
Make sure that the power to the ma-
chine is OFF before installing or per-
forming maintenance or repairs. All
electrical work should be performed by
a qualified electrician in strict accor-
dance with national and local safety
regulations. Installation, repairs and
other work by unqualified persons
could be dangerous.
Verify that the voltage, load and circuit
rating information found on the data
plate match the household electrical
supply. This data must match to pre-
vent damage to the coffee system. If in
doubt, consult a licensed electrician.
The necessary connection information
is given on the data plate inside your
appliance.
The coffee system comes equipped
with a 6ft (1.8m) power cord with a
NEMA 5-15P molded plug for connec-
tion to a 120V, 15A, 60Hz power sup-
ply.
Do not connect the appliance to a
power inverter or directly to power pro-
duced outside of the normal electrical
grid (i.e. direct solar or wind power
source).
Direct connection to such power
sources can cause power surges and
tripped breakers when the appliance is
turned on, and could damage the appli-
ance.
Do not connect the appliance to energy
saving plugs or outlets. The reduction
of power to the appliance caused by
these devices will cause the appliance
to run hot and may damage it and/or
shorten its usable life.
If there is any question concerning the
electrical connection of this appliance
to your power supply, please consult a
licensed electrician or contact Miele’s
Technical Service Department. See
back page for contact information.
WARNING:
THIS APPLIANCE MUST BE
GROUNDED