Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the appliance
- Operation
- Miele@home
- Before first use
- The bean system
- Filling the water tank
- Switching on and off
- Dispenser adjustment
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Portion size
- Resetting drinks
- Profiles
- Profiles: Creating and processing drinks
- MyMiele
- MobileStart
- Settings
- Displaying and changing settings
- Language
- Time
- Date
- Start screen
- Timer
- Volume
- Display
- Lighting
- Info (display information)
- Fresh water
- Altitude
- Performance Mode
- Water hardness
- MotionReact
- System lock
- _
- Remote control
- SuperVision
- RemoteUpdate
- Software version
- Legal information
- Showroom program (Demo mode)
- Factory default settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Cleaning the drip tray and grounds container
- Cleaning the drip-tray cover
- Water container
- Cleaning the main dispenser
- Cleaning the cup-rim sensor
- Cleaning the milk flask with lid
- Cleaning the milk valve (daily)
- Removing and cleaning the milk valve (once a month)
- Cleaning the bean containers
- Removing the brew unit and cleaning it by hand
- Cleaning the interior, inside of the machine door, and drip tray
- Cleaning the front of the machine
- Maintenance programs
- Rinsing the machine
- Rinsing the milk pipework
- Maintenance program:
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Automatic cleaning and descaling
- Frequently Asked Questions
- Service and warranty
- Accessories
- Caring for the environment
- Installation
- FCC Declaration of Conformity
- Copyrights and licenses
Cleaning and care
73
Insert the holder and silicone seal
until they audibly click into place.
Connect together the angular molded
hose and longer milk pipework. Start
by attaching the top of the molded
hose to the main dispenser. The
black connecting piece should be
pointing to the rear.
Then, connect the bottom end of the
molded hose to the dispensing unit.
Insert the milk pipework into the milk
valve on the left and right-hand sides.
Push the connecting pieces into the
silicone seal as far as they will go.
Check that the milk pipework is snug
against the housing and that the
cover can be easily attached.
Tip: If necessary, screw the milk
pipework backward at the connecting
piece on the right-hand side.
Attach the milk-valve cover as
follows: insert the pin in the top right-
hand corner and swivel the cover
backward until a proper fit is
achieved.
Push the left-hand bean container
and maintenance container back into
the coffee machine. Attach the main
dispenser’s stainless-steel cover.
Close the appliance door.