Operating & Installation Instructions

Cleaning and care
72
1
2
3
 Detach the milk pipework from the
dispensing unit on the main
dispenser and from the milk-valve
silicone seal( and).
 Remove the milk pipework
connecting the milk valve to the main
dispenser.
 Disconnect the angular molded hose
from the round hose. Rinse the hoses
thoroughly under running water.
Do not remove the connecting pieces
from the hoses.
 Press the retainers on the left and
right-hand sides of the milk-valve
holder and pull the holder forward to
remove it.
 Take the holder and silicone seal
apart.
 Pull the stainless-steel bolt upward
and out.
 Clean the individual components of
the milk valve in the dishwasher.
Tip: If there are any dry milk residues
on the front, soak the stainless-steel
bolt in warm water and a little liquid
dish soap.
Installing the milk valve
 Insert the stainless-steel bolt from
above.
 Insert the silicone seal into the milk-
valve holder.