Operating and Installation Instructions Ventilation System DA 1160 DA 1180 To prevent accidents and appliance damage, read these instructions before installation or use. en - US M.-Nr.
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Description of functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Guide to the ventilation system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Turning the light on/off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Fan control . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Keep these instructions in a safe place and pass them on to any future user. Read these instructions carefully before installing or using the Ventilation System. ~ This appliance is intended for residential use only. Use the appliance only for its intended purpose. ~ This appliance complies with current safety requirements. Improper use of the appliance can lead to personal injury and material damage.
IMPORTANT SAFETY INSTRUCTIONS ~ d) Before connecting the appliance to the power supply make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent appliance damage. If in doubt consult a qualified electrician. ~ e) Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and other work by unqualified persons could be dangerous.
IMPORTANT SAFETY INSTRUCTIONS ,WARNING TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A COOKTOP GREASE FIRE, OBSERVE THE FOLLOWING*: ~ Do not allow children to play with or ~ a) SMOTHER FLAMES with a close fitting lid, cookie sheet, or metal tray then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. ~ Never operate gas burners without ~ b) NEVER PICK UP A FLAMING PAN - You may be burned.
IMPORTANT SAFETY INSTRUCTIONS Installation ~ g) Do not install this hood over cooktops that burn solid fuel. ,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: ~ a) Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
Description of functions The ventilation system can be operated: Air extraction Recirculation mode The air is drawn in and cleaned by the grease filters and directed outside. The air is drawn in and cleaned by the grease filter as well as an odor-free filter (optional accessories). The filtered air is then recirculated back into the kitchen. The hood comes equipped with a non-return flap.
Guide to the ventilation system 8
Guide to the ventilation system a Control panel Turning the light on/off b Overhead lighting The overhead light and the fan can be turned on and off separately j. c Odor-free filter (active charcoal filter) "0" – Light off Optional accessory for recirculation mode "1" – Light on d Cover for the odor-free filter duct Fan control e Grease filter f Vent collar C 125 mm or 150 mm ^ This switch k allows you to turn the fan on and off and to select the fan power level.
Cleaning and care ,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety Instructions". Avoid: – cleaning agents containing soda, acids or chlorides, – abrasive cleaning agents e.g. powder or cream cleansers, – abrasive sponges, e.g. pot scourers or sponges which have been previously used with abrasive cleaning agents. These will damage the surface.
Cleaning and care Special instructions for appliances with a colored (RAL) housing. It is very difficult to clean this type of surface without causing minor marks on the surface material. This can become particularly noticeable if there is halogen light in the kitchen. Stainless steel colored controls These controls may become discolored or damaged if not cleaned regularly. Do not use a stainless steel cleaner on these controls.
Cleaning and care Cleaning the filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. They could destroy the filter. ^ In a dishwasher: place the filter vertically in the lower basket, making sure that the spray arm is not blocked. Use a wash program with a max. temperature of 150°F (65°C). In a Miele dishwasher use the "Normal" program.
Cleaning and care Odor-free filter (active charcoal ^ Remove the odor-free filter from the packaging. filter) For recirculation mode an odor-free filter must be used in addition to the grease filter. The odor-free filter is designed to absorb cooking odors. It is inserted above the grease filter. ^ Insert the odor-free filter into the duct and push upward until it is positioned under the vent. ^ Remove the grease filters.
Cleaning and care Changing the light bulbs ^ Remove the grease filter. ,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before changing the light bulbs, disconnect the hood from the power supply, see "Important Safety Instructions". When in use halogen bulbs become extremely hot, and can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool. ^ Loosen the light fastening screw slightly.
After Sales Service Repairs MieleCare In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department. (USA only) ^ When contacting the Technical Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter are removed.
Installation Instructions Read these instructions and the "Important Safety Instructions" before installing this ventilation system. The installation steps are described in the enclosed "Installation Diagram". Leave these instructions with the appliance for the consumer/user. Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information.
Caring for the environment Disposal of packing material Disposal of an old appliance The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. Old appliances may contain materials that can be recycled. Please contact your local recycling center about the possibility of recycling these materials. ,DANGER Ensure that any plastic wrappings, bags, etc.
Appliance dimensions DA 1160 . . . . . . . B = 23 9/16" (598 mm) DA 1180 . . . . . . .
Appliance dimensions Distance between cooktop and hood (S) Do not install this exhaust hood over cooktops burning solid fuel. Provided a larger distance is not given by the manufacturer of the cooktop, follow the minimum safety distances between a cooktop and the bottom of the hood: Miele Cooktops Non-Miele Cooktops Electric Cooktops 24" (610 mm) Electric Barbeques and Fryers 26" (660 mm) Multiburner Gas cooktops < 43,000 BTU (12.6 KW) and no burner > 15,000 BTU (4.
Installation Before installation read the information in the "Appliance Dimensions" and " Important Safety Instruction" chapters. This is especially crucial when using the ventilation system at the same time as another heat-producing appliance that uses air from the same room. ^ Remove the grease filter. The casing of stainless steel models is covered with a protective film to prevent scratching during transport. ^ Remove the film from the casing and from the grease filter frames before installing.
Installation Under-cabinet installation Several holes for fastening the device under a cabinet are provided in the top of the casing. ,Use only the holes on the drill template. Use only the specified screws. Faulty installation can damage the ventilation system and impair the electrical safety (e.g. electric shocks). ^ For operation in recirculation mode, cover the opening at the back with the sticker.
Installation ^ For extraction mode you must also drill a 6 3/4" (170 mm) hole through the bottom of the cabinet. ^ If you want to lay the power cord though the cabinet you must drill a hole for it, too. ^ Lift the hood up under the cabinet and feed the power cord through the respective hole in the bottom of the cabinet. ^ From the inside of the cabinet, fasten the hood to the cabinet using the screws provided. ^ Put the grease filter back in place.
Installation ^ Remove the overhead lights. ^ Slightly loosen the light fastening screw. ^ Fasten the wall anchors to the wall using the dowels and screws provided. ^ Slide the screw and the light down. ^ Fasten the screw again. ^ Turn the light counterclockwise and pull it out.
Installation For air extraction mode: ^ Attach the hood to the wall anchors. ^ Tighten the two screws at the left and the right on the back of the device. These are used to adjust the tilt and secure the hood in position. ^ For an C 6" (150 mm) exhaust duct, use a pointed knife to cut off the exhaust collar where it tapers. For an C 5" (125 mm) exhaust duct, use the collar as is. ^ If required, insert the non-return flap. Ensure that the flap opens easily and closes by itself.
Installation Observe the instructions in "Important safety instructions" and "Electrical connection". ^ Plug the power cord into the power outlet. ^ To carry out a function test, turn the fan on. – In extraction mode, no air should come out of the air outlet at the front of the hood. ^ Fasten the exhaust duct to the exhaust collar e.g. using a flexible duct and a clamp (optional accessory). ^ Insert the exhaust collar into the exhaust opening and secure it by turning it clockwise.
Electrical connection ,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: All electrical work should be performed by a qualified electrician in strict accordance with national regulations (for USA: ANSI-NFPA 70) and local safety regulations. Installation, repairs and other work by unqualified persons could be dangerous. Ensure that power to the appliance is OFF while installation or repair work is performed.
Exhaust ducting ,WARNING Danger of toxic fumes. Gas cooking appliances release carbon monoxide that can be harmful or fatal if inhaled. To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be vented outside of the building only. Use smooth or flexible pipework made from approved non-flammable materials for exhaust ducting.
Exhaust ducting – If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, flue, or room venting ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent flue. Important! If the ductwork runs through rooms, ceilings, garages, etc. where temperature variations exist, it may need to be insulated to reduce condensation.
Exhaust ducting Condensate trap (optional accessory) In addition to appropriate insulation of the exhaust ducting, we recommend installing a condensate trap to collect and evaporate any condensation which may develop. This is available for ducts C 5" ( 125 mm) or C 6" ( 150 mm). When installing a condensate trap, ensure that it is positioned vertically and if possible directly above the exhaust outlet of the ventilation hood. The arrow on the casing indicates the exhaust flow direction.
Technical data DA 1160, DA 1180 Maximum load . . . . . . . . . . . . . . . 380 W Fan motor. . . . . . . . . . . . . . . 2 x 140 W Overhead lights . . . . . . . . . . . 2 x 50 W Voltage . . . . . . . . . . . . . . . . . . . . 120 V Frequency . . . . . . . . . . . . . . . . . . 60 Hz Fuse rating . . . . . . . . . . . . . . . . . . . 15 A Length of the power cord . . . . . . . . . . . . 6' 6 3/4" (2 m) Weight DA 1160. . . . . . . . . . . 24.7 lbs (11.2 kg) DA 1180. . . . . . . . . . . 28.4 lbs (12.
Alteration rights reserved / 0313 M.-Nr. 09 382 400 / 00 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.
