Operating and installation instructions Cooker hood DA 186 To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZHr M.-Nr.
Contents Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Modes of operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Operation . . . . . . . . . . . . . . . . . . . . .
Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Packaging (e.g. cling film, polystyrene) and plastic wrappings must be kept out of the reach of babies and young children.
Warning and Safety instructions This appliance complies with all relevant legal safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time. They contain important information on the safety, installation, use and maintenance of the appliance.
Warning and Safety instructions The appliance is only completely isolated from the electricity supply when: – it is switched off at the wall socket and the plug withdrawn, – the fuse from the fused spur connection unit is withdrawn, – the mains fuse is withdrawn, or – the screw-out fuse is removed in countries where this is applicable. Do not connect the appliance to the mains electricity supply by an extension lead. Extension leads do not guarantee the required safety of the appliance (e.g.
Warning and Safety instructions Safety with children Installation The appliance is only intended for use by adults who have read these operating instructions. Keep children well away from the appliance at all times and supervise them when you are using it. The distance betwen the top of the cooker/hob and the bottom of the cooker hood must measure at least 650 mm, unless a greater distance is specified by the manufacturer.
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Warning and Safety instructions Disposal of your old appliance Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut off the cable directly behind the appliance to prevent misuse. This should be done by a competent person. The manufacturer cannot be held liable for damage caused by non-compliance with these Warning and Safety instructions.
Modes of operation The cooker hood works with . . . air extraction: . . . air recirculation: The air is drawn in and cleaned by the grease filters and directed outside. The air is drawn in and cleaned first by the grease filters and then by two charcoal filters. If the on-site ventilation system does not have a non-return flap, the non-return flap supplied must be fitted. This flap is closed when the cooker hood is switched off. No exchange of room and outside air can take place.
Guide to the appliance 10
Guide to the appliance a Recirculation grille (only for recirculation mode) c Adjustable bracket It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the air, whether you are using air extraction or recirculation mode. d Vapour canopy to which a furniture door front is fitted ^ To switch the fan off, close the vapour canopy.
Cleaning and care Before carrying out any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: - it is switched off at the wall socket and the plug removed, or - the fuse is withdrawn from the fused spur connection unit, or - the mains fuse is withdrawn, or - the screw-out fuse is removed (in countries where this is applicable). Housing The surfaces and controls are susceptible to scratches and abrasions. Please observe the following cleaning instructions.
Cleaning and care ^ Clean the filters - by hand: with a soft nylon brush, warm water and a little washing up liquid. - in a dishwasher: place filters upright in the lower basket, and wash on a 65° programme, ensuring that the spray arm is not obstructed. Depending on the cleaning agent used, cleaning the grease filters in a dishwasher can cause permanent discolouration to the surface of the filters. However, this will not affect the functioning of the grease filters in any way.
Cleaning and care Changing a halogen lamp Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that - it is switched off at the wall socket and the plug removed, or - the fuse is withdrawn from the fused spur connection unit, or - the mains fuse is withdrawn,or - the screw-out fuse is removed (in countries where this is applicable). Exercise caution when changing halogen lamps. They get very hot during use, and remain hot for some time after being switched off.
After sales service In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – your Miele Dealer or – the Miele Service Department (see back cover for contact details). When contacting the Service Department, please quote the model and serial number of your appliance These are shown on the data plate which is visible when the grease filter is removed. Please note that telephone calls may be monitored and recorded for training purposes.
Appliance dimensions * Furniture panel dimensions Connection for air extraction C 150 mm, or C 120 mm with reducing collar. Safety distance between hob and cooker hood The distance betwen the top of the cooker/hob and the bottom of the cooker hood must measure at least 650 mm, unless a greater distance is specified by the manufacturer. For further advice, see Warning and Safety instructions.
Installation Before installation, it is important to read the information given on the following pages as well as the Warning and Safety instructions at the beginning of this booklet. This is particularly crucial when using the cooker hood at the same time as a heating appliance that relies on oxygen from the same room, which could result in the build-up of toxic fumes. ^ Take the filter out and then remove the protective foil from around the filter frame.
Installation Depth adjustment Fitting the cooker hood to the wall ^ Cut the drilling template for the wall fitting to size, and position against the wall. ^ The depth of the unit "T" can be adjusted from 275 to 360 mm by means of the adjustable brackets. ^ Slightly loosen the front screws on the brackets. ^ Then pull the brackets out until you achieve the required depth "T". ^ Tighten the screws up again.
Installation ^ Position the vapour canopy with the furniture door front fitted, and close it. ^ The recirculation grille must be removed when the hood is used in extraction mode. The movement of the vapour canopy can be adjusted if necessary, for instance where a heavy furniture door is fitted. The adjusting screws are accessed through openings on either side of the appliance. ^ Remove both cover caps. ^ Hang the cooker hood in position using the adjustable brackets.
Installation Height adjustment Securing the appliance to neighbouring wall units or fitting side panels ^ Remove the vapour canopy. ^ Remove the grease filters. ^ Using the screws at the back of the adjustable brackets, align the cooker hood height with that of neighbouring units. Turn the screw – clockwise : to lower the appliance. ^ Secure the cooker hood to the neighbouring units, or fit the side panels, using two screws each side.
Installation With air extraction: ^ Finally refit the grease filters. ^ If the on-site ventilation system does not have a non-return flap, the non-return flap supplied must be fitted. ^ For extraction connection, secure a flexible ducting or an extraction pipe to the exhaust connection using a hose clip. ^ Proceed with the exhaust connection. (see Connection for air extraction). With recirculation mode: ^ Fit the charcoal filters (see Cleaning and Care).
Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7651 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. Ensure power is not supplied to the appliance until after installation or repair work has been carried out.
Connection for air extraction Important: To avoid the danger of toxic fumes, please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local and national building regulations. Seek approval from the building inspector where necessary. – Where ducting is horizontal, it must be laid to slope away at at least 1 cm per metre.
Technical data Total connected load . . . . . . . . . . 175 W Fan motor . . . . . . . . . . . . . . . . . 135 W Hob lighting . . . . . . . . . . . . . . 2 x 20 W Voltage. . . . . . . . . . . . . . . . . . AC 230 V Frequency. . . . . . . . . . . . . . . . . ~ 50 Hz Fuse rating (UK) . . . . . . . . . . . . . . . . 3 A Electrical cable length . . . . . . . . . 1.8 m Fan performance Extraction power according to EN 61591 Extraction system C 150 mm: Level I . . . . . . . . . . . . . . . . . . .
Alteration rights reserved / 4605 M.-Nr.
