Operating and installation instructions Cooker hood DA 2250, DA 2250 EXT DA 2270, DA 2270 EXT DA 2210 To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time. en - GB M.-Nr.
Contents Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Modes of operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Operation . . . . . . . . . . . . . . . . . . . . .
Caring for the environment Disposal of the packing material Disposal of your old appliance The packaging is designed to protect the appliance from damage during transportation. The packaging materials used are selected from materials which are environmentally friendly for disposal, and should be recycled. Electrical and electronic appliances often contain valuable materials.
Warning and Safety instructions This appliance complies with all relevant local and national safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time. They contain important information on safety, installation, use and maintenance. Keep these instructions in a safe place and ensure that all users are familiar with the contents.
Warning and Safety instructions Technical safety ~ Before installation, check the cooker hood for visible signs of damage. Do not install and use a damaged appliance. It could be dangerous. ~ Before connecting the appliance to the mains supply, make sure that the voltage and frequency details given on the data plate correspond with the household electricity supply, otherwise the appliance could be damaged. Consult a qualified electrician if in any doubt.
Warning and Safety instructions ~ Do not connect the appliance to the mains electricity supply by a multi-socket adapter or an extension lead. These do not guarantee the required safety of the appliance (e.g. danger of overheating). Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes ~ For appliances with an external fan motor (...EXT models) the connection of the two units must be made using the connection cable and the plug connectors.
Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heating appliance are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Warning and Safety instructions Correct use ~ Never use an open flame beneath the cooker hood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the cooker hood could draw flames into the filter. Fat particles drawn into the cooker hood present a fire hazard. ~ When using the cooker hood over a gas hob, ensure that any burners in use are always covered by a pan. Switch the cooking zone off when a pan is removed, even for a short time.
Warning and Safety instructions Correct installation Accessories ~ Refer to the cooker or hob manufacturer's instructions as to whether a cooker hood may be operated above the cooker/hob. ~ Only use genuine Miele original ~ The minimum safety distances between the top of the cooker or hob and the bottom of the cooker hood given in the "Appliance dimensions" section of this booklet must be maintained, unless the hob manufacturer states that a greater safety distance is required.
Guide to the appliance 10
Guide to the appliance a Control panel b Joystick This is used to operate the fan settings and the lighting. c Hob lighting d Charcoal filters Special accessory for recirculation mode DA 2250, DA 2270: 2 filters DA 2210: 4 filters e Grease filters f Fan setting indicator lamps g Touch control for the run-on option i Touch control for the charcoal filter The indicator lamp for the charcoal filter lights up when the charcoal filters used in recirculation mode needs to be replaced.
Modes of operation The cooker hood works with . . . air extraction: . . . air recirculation: The air is drawn in and cleaned by the grease filters and directed outside. (requires a conversion kit and charcoal filters: see "Technical Data") If the on-site ventilation system does not have a non-return flap, then the non-return flap supplied with the appliance must be fitted in the exhaust socket in the motor unit.
Operation Joystick To select a power level This is used to operate the fan settings and the lighting. ^ Press the joystick repeatedly to the right to select a higher power level, and to the left to select a lower power level. To switch the fan on The relevant power level indicator lamp will light up. Depending on the intensity of the cooking vapours, levels "I" to "III" are usually sufficient for normal cooking. Intensive setting ^ Press the joystick once to the right.
Operation Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ To set this option, both the fan and the hob lighting must be switched off. ^ Press the run-on option control for approximately 10 seconds. The first power level indicator lamp will light up. ^ Press the joystick – once to the rear or to the front. The second indicator lamp will light up, – then press the joystick once to left.
Operation To switch the hob lighting on To switch the hob lighting off The hob lighting can be switched on and off independently of the fan. ^ Press the joystick again once to the rear or to the front to switch it off. Safety cut-out Should the cooker hood be left on, the fan will switch off automatically after 10 hours. The lighting will remain on. ^ Pressing the joystick once to the right will switch the fan back on again. ^ Press the joystick once to the rear or to the front to switch it on.
Operation Filter operating hours counter The number of hours the appliance has been in operation is stored in memory. The operating hours counter tells you when the grease filters or charcoal filters need to be cleaned or replaced. Reading the grease filter operating hours counter To check the percentage of time set already used: ^ Switch the fan on with the joystick. Resetting the grease filter operating hours counter ^ Press and hold the grease filter control.
Operation Altering the grease filter operating hours counter The operating hours counter for the grease filter is set at the factory for 30 hours. This can be lengthened or shortened to suit the type of cooking you do. You can choose 20, 30, 40 or 50 hours. – Select a short time if you roast or fry a lot. – If you use very little fat for cooking, select a longer time.
Operation Activating and altering the charcoal filter operating hours counter (in recirculation mode) The charcoal filters must be fitted for the cooker hood to be used in recirculation mode. On delivery, the operating hours counter for the charcoal filter is deactivated. For recirculation mode, the operating hours counter needs to be set to suit the type of cooking you do: ^ Switch the fan off with the joystick. ^ Press the run-on option control and the charcoal filter control at the same time.
Operation Resetting the charcoal filter operating hours counter Reading the charcoal filter operating hours counter To check the percentage of time set already used: ^ Switch the fan on with the joystick. The indicator lamp for the charcoal filter control will light up after the cooker hood has operated for the number of hours set. The charcoal filters must be replaced with new ones. Afterwards, the charcoal filter operating hours counter must be reset.
Cleaning and care A range of Miele branded cleaning and conditioning agents are available to order through your Miele Dealer / Chartered Agent, the Miele Spare Parts Department, or via the internet on www.miele-shop.com. ,Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. ,Halogen lamps get very hot during use and remain hot for some time after being switched off. The hot lamps are also susceptible to damage from damp cleaning.
Cleaning and care Cleaning the grease filters in the dishwasher ^ Place the filters as upright as possible in the lower basket, with the short sides upright. Make sure that the spray arm can move freely. ^ Do not wash at more than 65° C. If a Miele dishwasher is being used, select the Sensor wash programme. ^ To take out the grease filters, release the locking clip on the filter, lower the filter 45°, unhook it at the back and remove it.
Cleaning and care ^ When removing the filters for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire. When putting the grease filters back in position, ensure that the locking clips are facing down towards the hob. Fitting and replacing the charcoal filters If the cooker hood is connected for recirculation, charcoal filters must be inserted in addition to the grease filters.
Cleaning and care Always replace the charcoal filters immediately if – the indicator lamp for the charcoal filter control lights up, or – they are no longer effective in absorbing kitchen odours. They should, however, be replaced at least every 6 months. Used charcoal filters can be disposed of with the normal household waste. ^ After fitting the new charcoal filters, press the charcoal filter touch control for approximately 3 seconds to reset the operating hours counter.
Cleaning and care Changing a halogen lamp Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. ^ Remove the grease filter. ^ Remove the charcoal filters if the cooker hood is being used in recirculation mode. ,Exercise caution when changing halogen lamps. They get very hot during use, and remain hot for some time after being switched off.
After Sales Service In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent or – The Miele Service Department (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter is removed.
Appliance dimensions *Cut-out dimensions A depth T of at least 25 mm must be provided at the back of the building-in niche.
Appliance dimensions Safety distance between hob and cooker hood (S) The following minimum safety distance must be maintained between the top of the cooker/hob and the bottom of the cooker hood unless a greater distance is specified by the manufacturer of the cooker or hob: Cooking appliance Distance S Electric hob 450 mm Open Grill 650 mm Deep fat fryer (electric) 650 mm Multi-burner gas hob with a maximum total output of 12.6 kW, no burner exceeding 4.5 kW.
Installation Fitting the non-return flap (not needed for recirculation mode) ^ Place the appliance in the cut-out from below and align it. ^ If a non-return flap is not present in the venting system, the non-return flap supplied must be fitted onto the exhaust socket in the motor unit. The flaps must open upwards. DA 2250, DA 2270: 1 non-return flap DA 2210: 2 non-return flaps ^ Secure the cooker hood by the frame using 3.5 x 16 mm screws.
Installation ^ See "Connection for air extraction" for further instructions on fitting the ducting. Preparation for extraction ^ DA 2210: The hood has two exhaust connections for use with two 150 mm diameter exhaust hoses. A Y- adapter is supplied with the hood. It may be used to feed the exhaust from both connections to a 200 mm diameter common duct. ^ When using C 150 mm ducting, secure the exhaust connection supplied to exhaust ducting with hose clips.
Installation Recirculation A non-return flap is not used in recirculation mode. ^ Take the on-site conditions into account when fitting the conversion kit. When fitting the exhaust grille make sure that the slats in the grille point towards the centre of the room and not directly towards a wall or the ceiling. ^ Fit the charcoal filters and set the filter operating hours counter (see "Cleaning and Care").
Installation Fitting the joystick 4. Then tighten the screw with a 3 mm allen key. Continue to counterhold the joystick with an SW 9 spanner. Do not turn the spanner. Joystick extension The joystick can be extended if required (special accessory - Miele DBV 100). 1. Screw the spring into the holder and tighten by hand. Whilst doing so counterhold the joystick with an SW 9 spanner. Do not turn the spanner! 2.
Installation Electrical connection ^ If the cooker hood is to be connected to an external motor (EXT models): Use the connection cable with 6 pole plug to connect the cooker hood and the external motor. ^ Connect the appliance to the mains via a fused spur or fused socket as appropriate. Before connecting the appliance read the safety notes in "Warning and Safety instructions" and "Electrical connection".
Connection for air extraction Important: To avoid the danger of toxic fumes, please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local and national building regulations. Seek approval from the building inspector where necessary.
Connection for air extraction – If the exhaust air is to be ducted into the open air, the installation of a telescopic wall vent or roof vent (available as an optional accessory) is recommended. Condensate trap (optional accessory) – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue. Important: If the exhaust ducting is to run through rooms, ceiling space etc.
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the fan, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to the ducting exit a. ...in recirculation mode: The silencer needs to be positioned between the fan and the exhaust grille b. The space needs to be checked in some cases.
Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. Ensure power is not supplied to the appliance until after installation or repair work has been carried out.
Operation with Control module DSM 400 The Miele DSM 400 control module can be used to combine the cooker hood with other components. It enables the following: Potential free connection This can be used to operate a further appliance via the On/Off button s on the cooker hood. Components used in the central ducting system are not supplied by Miele. If in any doubt, the advice of a competent builder or, for gas, a Gas Safe installer must be sought.
Technical data Total connected load* DA 2250, DA 2270. . . . . . . . . . . . 300 W DA 2210. . . . . . . . . . . . . . . . . . . . 780 W – Fan motor DA 2250, DA 2270 . . . . . . . . . . 200 W DA 2210 . . . . . . . . . . . . . . . 2 x 290 W – Hob lighting DA 2250, DA 2270 . . . . . . . . 2 x 50 W DA 2210 . . . . . . . . . . . . . . . . 4 x 50 W Voltage . . . . . . . . . . . . . . . . . AC 230 V Frequency . . . . . . . . . . . . . . . . . . 50 Hz Fuse rating GB . . . . . . . . . . . . . . . . .
Alteration rights reserved / 2613 M.-Nr.