Operating and installation instructions Cooker hood DA 249-4, DA 249-4 EXT, DA 249-4 Alu, DA 249-4 Alu EXT To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time. GiWOZ M.-Nr.
Contents Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Modes of operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Guide to the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Operation . . . . . . . . . . . . . . . . . . . . .
Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and can normally be recycled. Packaging e.g. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children.
Warning and Safety instructions This appliance complies with all relevant legal safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time. They contain important information on the safety, installation, use and maintenance of the appliance.
Warning and Safety instructions The appliance is only completely isolated from the electricity supply when: – it is switched off at the wall socket and the plug withdrawn, – the fuse from the fused spur connection unit is withdrawn, – the mains fuse is withdrawn, or – the screw-out fuse is removed (in countries where this is applicable). Do not connect the appliance to the mains electricity supply by an extension lead. Extension leads do not guarantee the required safety of the appliance (e.g.
Warning and Safety instructions The grease filters should be regularly cleaned or changed as appropriate. Saturated filters are a fire hazard. See "Cleaning and care". Do not use a steam-cleaner to clean this appliance. Pressurised steam could reach the electrical components and cause a short circuit. Safety with children The appliance is only intended for use by adults who have read these instructions.
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Warning and Safety instructions One of the following technical measures may be necessary to ensure safe operation. – If the only way of ensuring adequate ventilation is via an open window, a window contact switch should be fitted to ensure that the cooker hood can only operate when the window is opened sufficiently. A window contact switch kit is available from good builders' merchants. Take care when ventilating the room through an open window that ventilation is not impaired by a closed blind or curtain.
Modes of operation The cooker hood works with . . . air extraction: The air is drawn in and cleaned by the stainless steel outer filter and the grease filter, and then directed outside. If the on-site ventilation system does not have a non-return flap, then the non-return flap supplied with the appliance must be fitted Having a non-return flap fitted in the ducting ensures that air, once ducted to the outside, cannot get back into the room again. The flap is closed when the cooker hood is switched off.
Guide to the appliance 10
Guide to the appliance a Telescopic extension piece m Touch control for the grease filter b Recirculation grille The indicator lamp for the grease filter touch control lights up when the grease filter and the outer filter need to be cleaned. (optional accessory for recirculation mode only.
Operation To switch the fan on ^ Press the On/Off control. The fan will come on at power level "II". Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ To set this option, both the fan and the hob lighting must be switched off. The indicator lamp will come on.
Operation Run-on option The indicator lamps for fan power levels I and IV will flash if the automatic switch-off for the Intensive setting is not activated. ^ Press the + control to activate automatic switch-off. The indicator lamps for fan power levels I and IV will now light up constantly. Press the – control to deactivate the automatic switch-off function. ^ Press the run-on option control to confirm.
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on and off independently of the fan. Should the cooker hood be left on, the fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to switch on the hob lighting. The indicator lamp will come on. The hob lighting will switch on at maximum brightness. To dim the hob lighting ^ Pressing the On/Off control will switch the fan back on again.
Operation Reading the filter operating hours counter Altering the filter operating hours counter To check the percentage of time set already used: The filter operating hours counter is set at 30 hours. This can be lengthened or shortened to suit the type of cooking you do. You can choose 20, 30, 40 or 50 hours ^ Press the On/Off control to switch the fan on. ^ Press and hold the grease filter control. – Select a short time if you roast or fry a lot.
Operation Activating and altering the operating hours counter for the charcoal filter (in recirculation mode) The – / + indicator lamps show the time which has been set: 1st lamp from the left = 20 hours 2nd lamp from the left = 30 hours 3rd lamp from the left = 40 hours 4th lamp from the left = 50 hours ^ Use the – / + controls to select the desired time. ^ Confirm the selection by pressing the grease filter control. The charcoal filter is needed for recirculation mode.
Operation ^ Use the – / + controls to select the desired time. Reading the operating hours counter for the charcoal filter To check the percentage of time set already used: ^ Confirm the selection by pressing the charcoal filter control. All the indicator lamps will go out. ^ Press the On/Off control to switch the fan on. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data. ^ Press and hold the charcoal filter control.
Cleaning and care Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the wall socket and the plug removed, or – the fuse is withdrawn from the fused spur connection unit, or – the mains fuse is withdrawn, or – the screw-out fuse is removed (in countries where this is applicable).
Cleaning and care Important for appliances with aluminium housing: Aluminium is affected by the way that light falls on it, by the surrounding environment and by the angle you observe it from. Aluminium surfaces and controls may suffer discolouration or damage if soiling is left on for too long. Remove any soiling straight away. Observe the General notes on cleaning earlier in this section.
Cleaning and care To remove the stainless steel outer filter Cleaning the grease filter and the outer filter by hand ^ Clean the grease filter and the outer filter with a soft nylon brush in a mild solution of hot water and a little washing-up liquid. Do not use "neat" washing up liquid. Do not use: – cleaning agents containing descaling agents, ^ To remove the outer filter pull down on the quick-release catches. When doing this, hold the filter securely so that it does not fall on the hob surface below.
Cleaning and care ^ After cleaning, leave the filters to dry for a while on an absorbent surface before putting them back in place. To replace the stainless steel outer filter ^ When removing the filters for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire. ^ After cleaning the filters, press the grease filter control for approx. 3 seconds to reset the operating hours counter. The indicator lamp will go out.
Cleaning and care Fitting and replacing the charcoal filter If the cooker hood is connected for recirculation, a charcoal filter must be inserted in addition to the grease filter. This is designed to absorb cooking odours. It is fitted in the chimney above the grease filter. Replacement charcoal filters can be obtained from your dealer or the Miele Spare Parts department. See back cover for contact details, and "Technical data" for type and reference number.
Cleaning and care Always replace the filter immediately if the lamp for the charcoal filter touch control comes on, or if it is no longer effective in absorbing kitchen odours. It should be replaced at least every 6 months. Used charcoal filters can be disposed of with the normal household waste. ^ After fitting a new charcoal filter, press the charcoal filter touch control for approx. 3 seconds to re-set the operating hours counter. The indicator lamp will go out.
Cleaning and care Changing a halogen lamp Disconnect the cooker hood from the mains supply by: – switching it off at the wall socket and removing the plug, or – withdrawing the fuse from the fused spur connection unit, or – withdrawing the mains fuse, or – removing the screw-out fuse (in countries where this is applicable). Exercise caution when changing halogen lamps. They get very hot during use, and remain hot for some time after being switched off.
After Sales Service In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer or – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance. These are shown on the data plate which is visible when the grease filter is removed. Please note that telephone calls may be monitored and recorded for training purposes.
Appliance dimensions 26
Appliance dimensions 1) Extraction 2) Recirculation 3) Ventilation grille positioned at the top for recirculation 4) and 5): (5 is not required for recirculation mode cooker hoods) The shaded area represents the wall or ceiling area for the vent cut-out, for fitting the connection socket and on EXT models for feeding the connection cable through to the external motor. For recirculation mode, only a connection socket needs to be fitted.
Installation Assembly parts 28
Installation a 2 protective sheets for use when fitting the tower. b 2 hose clips for securing the exhaust ducting. 2 x M 6 self-tapping nuts for securing the appliance. c 1 reducing collar for exhaust ducting C 125 mm (not on EXT models). d 1 non-return valve for fitting into the exhaust connection on the motor unit (for extraction mode only, not on EXT models). e Upper retaining plate for securing the extension piece. f Middle retaining plate for securing the extension piece. 2 screws 3.9 x 7.
Installation Dismantling Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and Safety instructions" at the beginning of this booklet. This is particularly crucial when using the cooker hood at the same time as a heating appliance that relies on oxygen from the same room to avoid the danger of toxic fumes building up.
Connection for air extraction Important: To avoid the danger of toxic fumes please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local and national building regulations. Seek approval from the building inspector where necessary. – Where ducting is horizontal, it must be laid to slope away at at least 1 cm per metre.
Connection for air extraction Important: Silencer If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. Condensate trap (optional accessory) To achieve even further reductions in noise levels, a special silencer can be fitted in the ducting system.
Electrical connection be provided for all poles. All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. Ensure power is not supplied to the appliance until after installation or repair work has been carried out.
Operation with Control module DSM 400 The Miele DSM 400 Control module can be used to combine the cooker hood with other components. It enables the following: Connection to a window contact switch If adequate ventilation to the room can only be ensured by having a window open when the cooker hood is in use at the same time as a heating appliance which depends on the air from the same room, then the control module can be used to connect a window contact switch (not supplied) to the appliance.
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. The control module is supplied with its own detailed operating and installation instructions.
Technical data Total connected load* . . . . . . . . . 240 W – Fan motor* . . . . . . . . . . . . . . . . 200 W – Hob lighting . . . . . . . . . . . . . 2 x 20 W Halogen lamps Osram type 44890 WFL, 20 W Voltage UK, NZ, ZA . . . . . . . . . . . . . . . AC 230 V AUS . . . . . . . . . . . . . . . . . . . . AC 240 V Frequency . . . . . . . . . . . . . . . . . . 50 Hz Fuse rating (UK) . . . . . . . . . . . . . . . . 3 A AUS, NZ: Plug rating . . . . . . . . . . . . . . . . . . .
Alteration rights reserved / 1306 M.-Nr.
