Operating and Installation instructions

Before using for the first time
17
Settings with the canopy
retracted
The ventilation hood must be switched
off before activating settings. The
canopy must be retracted. In order to
reach the controls when the canopy is
retracted, please note the following:
 Remove the grease filters.
The controls are accessible via the slots
for the grease filters.
Selecting extraction mode or
recirculation mode
The ventilation hood can be operated
with either extraction mode or
recirculation mode. The power of the
blower is adapted to suit the selected
mode of operation. The ventilation
hood is set up at the factory for
recirculation mode. The ventilation
hood has to be reset for extraction
mode.
To reset it for extraction mode, the filter
saturation indicator for the charcoal
filter(s) has to be deactivated.
 Switch off the blower and the lighting.
 Press the control and the
operating-hours control at the
same time.
The charcoal filter symbol and one of
the blower power level indicators will
flash.
 Press and hold the control until the
B indicator starts to flash.
 Confirm the selection by pressing the
operating-hours control.
All the indicator lights will go out.
Extraction mode has now been set.
If the selection is not confirmed within
4minutes, the system will revert to the
previous setting.