Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Description of functions
- Guide to the appliance
- Operation (Automatic mode)
- Operation (Manual mode)
- Operation (Automatic and Manual modes)
- Cleaning and care
- Installation
- Air venting
- Electrical connection
- Activating Con@ctivity 2.0
- Service and warranty
- Technical data
Cleaning and care
28
After cleaning
After cleaning, leave the filters on an
absorbent surface to dry.
When removing the filters for
cleaning, also clean off any
accessible oil or fat buildup from the
housing. Doing so will prevent a fire
hazard.
Reinstall the grease filters. When
inserting the filters, make sure that
the locking clip is facing down.
If the filters have been installed
incorrectly, you can insert a small
screwdriver into the slit to disengage
the locking clip.
Resetting the filter saturation counter
for the grease filters
Once cleaning is complete, the filter
saturation counter must be reset.
While the fan is turned on, press the
filter saturation indicator for
approx. 3 seconds until 1 is the only
indicator flashing.
The grease filter symbol goes out.
When cleaning the grease filters before
the full operating time has elapsed:
Press the filter saturation indicator
for approx. 6 seconds until 1 is
the only indicator flashing.