Installation and Operation

Electrical connection
48
WARNING: TO REDUCE THE RISK
OF FIRE, ELECTRIC SHOCK, OR IN‐
JURY TO PERSONS, OBSERVE THE
FOLLOWING:
All electrical work should be per‐
formed by a qualified electrician in
strict acc
or
dance with national regu‐
lations (for USA: ANSI-NFPA 70) and
local safety regulations. Installation,
repairs and other work by unqualified
persons could be dangerous.
Ensure that power to the appliance is
OFF whil
e
installation or repair work
is performed.
Verify that the voltage, load and cir‐
cuit
rating information found on the
data plate (located behind the baffle
filters), match the household electri‐
cal supply before installing the hood.
Use only with ventilation hood cord-
connection kits that have been in‐
vestig
ated and found acceptable for
use with this model hood.
If there is any question concerning
the electrical connection of this ap‐
plian
ce t
o your power supply, please
consult a licensed electrician or call
Miele’s Technical Service Depart‐
ment.
WARNING: THIS APPLIANCE MUST
BE GROUNDED
Grounding Instructions
WARNING - Improper grounding can
resul
t in a risk of electric shock.
This appliance must be grounded. In
the event
of an electrical short cir‐
cuit, grounding reduces the risk of
electric shock by providing a path of
least resistance.plug.
If there is any doubt, have the elec‐
trical system of the house checked
by a qualified electrician.
To increase security before the ma‐
chine is installe
d, it is recommended
to install a protective switch(30mA).
 The
hood must be hard wired ac‐
cor
dingly:
Black/Red wire: connect to L1 (live)
White wire: connect to N (neutral)
Green wire: connect to GND (ground)