Operating Instructions and Installation Instructions

Problem solving guide
154
Problem Cause and remedy
A humming sound can
be
heard after
switching on the
appliance, during
operation and after
switching off the
appliance.
It is quite normal and does not indicate any fault with
the applianc
e. It happens when water is being
pumped through the system.
After moving house the
appliance no longer
switches fr
om the
heating-up phase to the
cooking phase.
The boiling temperature of the water has changed as
the altitude of the new location for the appliance
differs fr
om the old one by at least 300 m.
 T
o adjust the boiling temperature, you need to
descale the appliance (see "Cleaning and care -
Descaling").
During operation an
unu
sually large amount
of steam escapes, or
steam escapes from
parts of the oven where
it does not usually.
The door is not properly closed.
 Close
the door.
The door seal is not correctly fitted.
 P
ress it in all the way round the door to make sure
it is fitted evenly.
The door seal is damaged, e.g. cracks can be seen.
 Replace the door seal.
This can
be ordered from Miele (see the end of
this booklet for contact details).
The control panel will
not open or close
aut
omatically despite
touching the  sensor
several times.
Something is obstructing the control panel.
 Remove the obstruction.
The obstruction sensor is very sensitive and can
pr
event the panel opening or shutting if it picks up a
signal.
 Open/close the control panel manually (see end of
this section)
 If
the problem occurs again, contact Miele
Service.
The oven interior
lighting is not working.
The lamp is defective.
 C
all Miele Service to have the lamp replaced.