Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Guide to the appliance
- Before using for the first time
- Operation
- Keeping food warm
- Warming crockery
- Low temperature cooking
- Other uses
- Networking with Miele built-in appliances
- Sabbath mode
- Cleaning and care
- Problem solving guide
- Optional accessories
- After sales service
- Installation
- EU Conformity declaration
- UK Conformity declaration
Before using for the first time
19
Connecting via WPS
Your WiFi router must support WPS
(WiFi Protected Setup).
Switch the drawer off.
Press and hold the sensor control.
At the same time, touch the
sensor control.
2h will light up constantly, 3h will flash
on and off.
The WPS connection must be started
on the drawer at the same time as on
the WiFi router.
Touch the sensor control on the
drawer after a few seconds.
After a short while, 2h will light up con-
stantly, and 3h and 4h will flash on
and off.
The drawer will be ready for connection
in the next 10minutes.
Start the WPS connection on your
WiFi router.
When successfully connected, 2h and
3h will light up constantly.
Quit the connection mode on the
drawer by touching the sensor con-
trol.
The drawer can now be operated via
the app.
If the connection fails, you have prob-
ably not activated WPS on your router
quickly enough. Repeat the steps
above.
Tip: If your WiFi router does not support
WPS, please connect via the
Miele@mobile app.
Signing out of WiFi (resetting factory
defaults)
To set up a new WiFi connection, the
existing WiFi connection must be dis-
connected.
Switch the drawer off.
Press and hold the sensor control.
At the same time, touch the
sensor control.
With an existing WiFi connection, 2h
and 3h will light up constantly.
The drawer will be ready for disconnec-
tion in the next 10minutes.
Touch the sensor control.
2h will light up constantly, 3h will flash
on and off.
After a few seconds, 2h and 3h will
start flashing on and off. The connec-
tion has now been disconnected.
Quit the signing off mode on the
drawer by touching the sensor
control.
The WiFi connection has now been dis-
connected. A new connection can now
be set up.
Log off the WiFi if you are disposing of
your drawer, selling it or putting a used
drawer into operation. This is the only
way to ensure that all personal data has
been removed and the previous owner
will no longer be able to access the
drawer.