Operating and Installation instructions

Operation
30
 Place the lid on the container and
press it down.
 Open the drawer and the glass lid.
a
b
c
O
P
E
N
 Place the vacuum adapter over the
vacuum pump air-intake valve.
 Attach the connector to the con-
tainer lid. Make sure that the closure
of the lid is turned to “SEAL” (closed).
 Switch the drawer on with the On/
Off sensor control.
The segment bar indicator lights above
theVaccum and Sealsensor controls
light up.
 Touch the Containersensor control.
The segment bar indicator lights above
theVaccum and Sealsensor controls
go out. The segment bar indicator lights
above theContainer and sensor
controls light up.
 Touch the Containersensor control
repeatedly until the segment bar indi-
cator light for the required vacuum
setting lights up.
 Touch the Startsensor control.
The vacuum-sealing process will start.
The Startsensor control goes out and
the Stopsensor control lights up.
Leave the glass lid open for the entire
duration of the vacuum-sealing
process.
If an excessive amount of bubbles
form you can cancel the vacuum-seal-
ing process by pressing theStopsen-
sor control (see “Operation – Cancel-
ing a vacuum-sealing process”).