Manual Guide

Operation
24
 Place the lid on the container and
press it down.
 Open the drawer and the glass lid.
 Place vacuum adapter over the
vacuum pump air intake valve.
 Attach the connector  to the con-
tainer lid. Make sure that the closure
of the lid is turned to “seal” (closed).
 Switch the drawer on with the sen-
sor.
The and sensors will light up.
 Touch the sensor.
The and  sensors go out. The
and sensors light up.
 Touch the sensor repeatedly until
the segment for the required vacuum
level lights up.
 Touch the sensor.
The vacuuming process will start.
Leave the glass lid open for the en-
tire duration of the vacuuming
process.
If an excessive amount of bubbles
form, you can cancel the vacuuming
process by pressing the sensor
(see “Canceling a vacuuming
process”).
After the vacuuming process
An acoustic tone will sound.
 Detach the connector from the con-
tainer lid. Make sure that the closure
of the lid is still turned to
“seal” (closed).
 Remove the vacuum adapter from the
vacuum pump air intake valve.
Before starting a new vacuuming
process, check that the vacuum
adapter, the tube, and the vacuum
chamber are clean and dry.
Remove any soiling or liquid residues
if necessary.