Manual Guide
Installation
44
Aligning the front of the drawer
After integrating the combination appli-
ance, it may be necessary under certain
circumstances to align the front of the
drawer and adjust the gap between the
drawer and the combination appliance.
To help you do this, there are 2screws
behind the drawer front with which the
front is fixed to the drawer housing.
Open the drawer.
Loosen fixing screws on the right
and left of the drawer housing.
Danger of injury.
When the fixing screws are removed,
the drawer front is only hooked onto
the housing and can easily fall off.
Do not remove the fixing screws
completely.
Push the drawer up or down a little to
correct the alignment and the gap.
Tighten up the fixing screws.