Technical information

Technical Information
112
G1000 / G2000 Dishwashers
*1 If the dishwasher is hooked up to an external softener system, which operates
on the ion exchange principle (meaning salt reactivation), the water hardness
supplied by that system has to be set. If this value is not known, set to 10 gr/gal.
*2 If the electronic unit is replaced during service work, it must be programmed as
follows: First set the country version and model version, then switch the
dishwasher off. Repeat the accessing procedure and set the machine height,
then set the on-site water hardness.
*3 The version Southern Europe covers the following countries: Portugal,
France, The Netherlands, Belgium and Great Britain.
Save and Quit
Switch off the unit.
6.2.1.2 G2020 - Service Mode
Accessing
1. Press and hold the Start/Stop button.
2. Switch on the machine.
3. Release the Start/Stop button.
4. Immediately press and release the Start/Stop button 3 times and at the 3rd
time hold it until the Start/Stop LED flashes.
5. Release the Start/Stop button
If the Start/Stop LED has not started to flash within approx. 4 sec., the accessing
procedure must be repeated.
Acknowledgement indicator
Successful accessing of the Service mode is indicated by a slow flashing Start/Stop
LED (1 Hz).
Options
Refer to Tables: 6-6 through 6-7.