Technical information

Technical Information
G1000 / G2000 Dishwashers
Control
Dial
Position
Function Programming Display
Flashing Rhythm of
Rinse LED
Long Short Display
- - F0
- 1 F1
- 2 F2
1 1 F11
1 2 F12
1 3 F13
1 4 F14
1 8 F18
1 9 F19
2 4 F24
2 5 F25
2 6 F26
4 - F40
5 1 F51
5 2 F52
6 9 F69
8 - F80
Pos. 1: Fault
memory
display
Turn the control dial
to the 1 o’clock
position. While the
Rinse LED flashes,
make a note of the
fault code, then
press the Start/Stop
button. If the same
fault is shown
again, it means
only this one fault is
saved. If a further
fault is shown,
press the Start/Stop
button again.
Repeat this
procedure until all
faults are read.
If the Rinse LED is
off, no faults are
registered. The
flashing rhythm of
the Rinse LED
indicates which
faults are registered
in the fault memory.
1 o’clock
8 8 F88
Delete fault
memory
Turn the control dial
to the 1 o’clock
position. Press the
Start/Stop button
and hold it until the
Rinse LED goes
out.
If the Rinse LED is
off, the fault
memory no longer
contains any faults.
- - -
Table 6-7: G2020 Service Mode Options (Continued on Table 6-8)
113