Technical information

Technical Information
148
G1000 / G2000 Dishwashers
Flashing
rhythm of
Intake/Drain
LED
Function Programming Indication
Flashing rhythm of
SaniWash LED
Long Short Long Short Display
Press the Program
button 3x.
To check the
operating hours,
press the Program
button and hold
until the
Intake/Drain LED
flashes. Then press
the Program
button briefly. *1
The Intake/Drain LED
flashes 3x.
The flashing rhythm of
the SaniWash LED
indicates the saved
operating hours. Each
long flash of the
SaniWash LED
represents 1000 hours
and each short flash
100 hours.
- -
- 4
Pos 4:
Operating
hours
check
-
- 5
Pos. 5:
Control
Panel LED
test
Press the Program
button 4x.
To start the control
panel test: LED,
press the Program
button and hold
until the
Intake/Drain LED
flashes. Then press
the Program
button briefly. *1
The Intake/Drain LED
flashes 4x.
All LEDs are lit.
- - -
- 6
Pos. 6:
Control
Panel
Buzzer
Test
Press the Program
button 5x.
To start the control
panel test: Buzzer,
press the Program
button and hold
until the
Intake/Drain LED
flashes. Then press
the Program
button briefly. *1
The Intake/Drain LED
flashes 5x.
Buzzer on.
- - -
Table 6-30: G1180 / G2180 Service Mode (Continued from Table 6-29)
*1 To make the desired setting adjustments. Hold the Program button until the Intake/Drain Lt. is
blinking, then use the Program button to make your setting changes. Once done, hold the Program
button until the Intake/Drain Lt. is solid again.
Save and quit
Switch off the unit.