Technical information

Technical Information
156
G1000 / G2000 Dishwashers
Flashing
Rhythm of
Delay Start
LED
Function Programming Display
Flashing Rhythm of
Rinse LED
Long Short Long Short Display
3 8
Pos. 38:
Model
variant
setting (from
software
version ID
no. –818) *1
Press the Delay
start button 38
times. The Delay
start LED flashes 3
times slowly and 8
times rapidly
intermittently. Press
the Start/Stop
button as
appropriate to
make the desired
setting.
The Rinse LED is off
or flashes. The
display shows P and
a digit alternately.
Individual setting
possibilities depend
on model and
whether a circulation
pump with slide
shutter (WAW) and
sensor softener
(SEH) are fitted as
follows: P3 = G14xx,
G24xx (without
WAW, with SEH).
- 3 P3
Long Short Long Short Display
- 1 P1
- 2 P2
- 3 P3
- 4 P4
- 5 P5
3 9
Pos. 39:
Country
variant
setting *1
Press the Delay
start button 39
times. The Delay
start LED flashes 3
times slowly and 9
times rapidly
intermittently. Press
the Start/Stop
button as
appropriate to
make the desired
setting.
The Rinse LED is off
or flashes. The
display shows P and
a digit alternately.
The following
country versions can
be set: P1 = EUR
(Europe); P2 = AUS
(Australia); P3 =
USA, P4 = JPN
(Japan), P5 = I/E
(Italy/Spain), P6 =
SER (Southern
Europe) *2
- 6 P6
Table 6-35: G2420 / G2430 Programming Mode Options (Continued from Table 6-34)
Warning
Do not change settings in Position 36, 38 or 39. Any changes made will
affect the operation of the dishwasher.
*1 If the electronic unit is exchanged during service work, it must be programmed as
follows: First set the country variant and model variant, then switch off the unit,
repeat the accessing procedure and set the machine height. Then the on-site water
hardness must be set.
*2 The SER variant includes the following countries: Portugal, France, Netherlands,
Belgium and Great Britain.
Save and Quit
Switch off the unit