Technical information

Technical Information

G1000 / G2000 Dishwashers

GND To ground connector.

Hard wiring the dishwasher should only be done if required by electrical code.

Do not cut the plug off the power supply cord / plug and connect it directly to the

house wiring under any circumstances. This voids the warranty.

For hard wiring, the power cord must be removed from the appliance by

disconnecting the cord from the terminal box located at the lower left front of the

dishwasher, behind the Toekick and Service Panel. Pass the permanent power

supply cable through the strain relief and secure it directly to the terminal box.

THIS APPLIANCE MUST BE GROUNDED

1.4.2 Plumbing Connections

1.4.2.1 Intake Connection

The appliance is equipped with a five (5) foot long Double WaterProof System Intake

Hose; equipped with a ¾ inch female hose connection; for connection to a ¾ inch

male hose thread water supply valve.

1.4.2.2 Drain Connection

The appliance is equipped with a five (5) foot long Drain Hose for connection to a ¾

inch drain nipple.

1.4.3 Dimensions