Technical information

Technical Information
G1000 / G2000 Dishwashers
Function Programming Display
The display shows the options Off,
Normal and Loud. The function is
activated as standard
5)
.
Pos. 13:
Buzzer
activation /
deactivation
and volume
setting
Use the cursor buttons as
appropriate to select Buzzer,
then press the OK button. Use
the cursor buttons to make the
desired setting.
Pos. 14:
Audible
confirmation
signal
activation /
deactivation
Use the cursor buttons as
appropriate to select Keypad
tone, then press the OK button.
Use the cursor buttons to make
the desired setting.
An audible confirmation signal when
a touchpad is pressed is active as
standard. This is indicated in the
display by On. If the function is not
desired, select Off
Pos. 15:
Brightness
setting
Use the cursor buttons as
appropriate to select
Brightness, then press the OK
button. Use the cursor buttons
to make the desired setting.
The display brightness range has
17 steps shown in bar form.
Standard setting: 8.
Pos. 16:
Contrast setting
Use the cursor buttons as
appropriate to select Contrast,
then press the OK button. Use
the cursor buttons to make the
desired setting.
The display contrast range has 17
steps shown in bar form. Standard
setting: 8.
The display shows the options On
and Not in current program.
Pos. 17:
Standby
2)
activation /
deactivation
Use the cursor buttons as
appropriate to select Standby,
then press the OK button. Use
the cursor buttons to make the
desired setting.
The display shows the options On
(standard setting) and Off.
Pos. 18:
Memory
activation /
deactivation
Use the cursor buttons as
appropriate to select Memory,
then press the OK button. Use
the cursor buttons to make the
desired setting.
The display shows the options
Demo program, Demo in cont.
loop and Demo with sound.
Pos. 19: Dealer
demonstration
mode
activation.
Use the cursor buttons as
appropriate to Select Dealer,
then press the OK button.
Confirm Demo program
activation with the OK button.
Use the cursor buttons to make
the desired setting and press
any button to start the program.
To interrupt a started demo
program, press any button and
then confirm by pressing the
OK button.
Table 6-46: G2630 Programming Mode Options (Cont. from Table 6-45) (Cont. on Table 6-47)
175