Technical information

Technical Information
97
G1000 / G2000 Dishwashers
1. Open the door.
2. Remove the bottom basket.
3. Remove the filter combination.
4. Remove as much residual water as possible from the sump and drain hose.
5. Lay the dishwasher on its back.
5. Drip pan removal (5.1.2).
6. Pull off the float switch.
7. Disconnect its plug connections.
Note
When refitting the float, make sure that the side with the Mat. No.
faces downwards.
5.4.18 Sump Removal
1. Remove as much residual water as possible from the sump and drain hose.
2. Open the door.
3. Remove the bottom basket.
4. Remove the bottom spray arm.
5. Unscrew the bottom spray arm flange.
6. Remove the filter combination.
7. Lay the dishwasher on its back.
8. Drip pan removal, 5.1.2.
9. Remove the float switch.
10. Disconnect the hoses.
11. Disconnect the NTC sensor connections.
12. Drain pump removal (5.4.16).
13. Circulation pump removal (5.4.14).
14. Remove the heating wiring harness from the cable guide.
15. Unscrew the hose clip and remove it.
16. Remove the sump by pulling down strongly and evenly on the drain pump or
circulation pump connections.
17. Remove the sealing ring.
Note
When refitting, the following should be noted;
1. Fit the sealing ring on the metal flange on the cabinet.
2. Apply liquid detergent as a slip lubricant to the outer surface of
the seal.
3. Apply liquid detergent as a slip lubricant to the inside of the