Operating and Installation instructions

Selecting additional settings
66
Switching on, switching off, or
resetting the Water Filter Dis-
play
Depending on the quantity of ice cubes
produced, the Water Filter Display will re-
mind you approx. every 6months that
the IntensiveClear 2.0 charcoal filter
needs to be changed. Replace the water
filter will appear on the display.
See “Water filter – Replacing the water
filter” for instructions on how to replace
the IntensiveClear 2.0 charcoal filter.
The first time the IntensiveClear 2.0
charcoal filter needs to be changed,
the display will remind you automati-
cally; the reminder does not need to
be switched on separately.
Tip: If you have replaced the Intensive-
Clear 2.0 charcoal filter with an Inten-
siveClear 2.0 mesh filter, you can use
the Water Filter Display as a reminder to
clean the IntensiveClear 2.0 mesh filter.
See “Cleaning and care – Cleaning the
water filter (IntensiveClear 2.0 mesh fil-
ter)” for instructions on how to clean the
IntensiveClear 2.0 mesh filter.
Switching on the Water Filter Display

If the Water Filter Display has been
switched off once, it must be switched
on again if required.
 In Settings mode , use the  and
 sensor controls to select the Water
Filter Display and select OK to confirm
your selection.
 Use the  and  sensor controls to
select On and select OK to confirm
your selection.
The Water Filter Display has been
switched on.
Switching off the Water Filter Display

 Risk to health due to contami-
nated water.
If the IntensiveClear 2.0 charcoal fil-
ter is not replaced on a regular basis,
it may become contaminated.
Only switch off the Water Filter Display
if an external water filter has been at-
tached to your household water sup-
ply in place of the IntensiveClear 2.0
charcoal filter. In this case, you
should also use an IntensiveClear 2.0
mesh filter in place of the Intensive-
Clear 2.0 charcoal filter (see “Acces-
sories – Optional accessories”).
 In Settings mode , use the  and
 sensor controls to select the Water
Filter Display and select OK to confirm
your selection.
 Use the  and  sensor controls to
select Off and select OK to confirm
your selection.