User Guide and Installation Instruction
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS 4
- Guide to the freezer 8
- Before use 10
- Settings 11
- Temperature and door alarm 14
- Setting the temperature 15
- Using the freezer efficiently 17
- SuperCool 20
- Ice/Water Dispenser 21
- Automatic defrost 27
- Adjusting the interior fittings 28
- Cleaning and care 30
- Water filter 36
- Lead free certificate 41
- Frequently asked questions 42
- Causes of noises 48
- After sales service 49
- Caring for the environment 52
- Installation 53
- Installing the appliance 62
- Before you begin 62
- RemoteVision module installation 65
- Preparing the installation niche 66
- Sliding the appliance into the installation niche 70
- Aligning the appliance 71
- Attaching the appliance to the installation niche 72
- Preparing the custom door 74
- Attaching and aligning the custom door front 76
- Aligning the Ice/Water Dispenser 79
- Attaching the frame and the shelf 81
- Plumbing 82
- Electrical connection 85
- RemoteVision (optional accessory) 86
- Contact details 91
^ Pull the rear cover forward and out.
^
Loosen the water sensors and
carefully bend them upwards.
^
Carefully remove the drip tray using a
screwdriver if necessary.
Once the drip tray has been removed,
the four metal strips can be used to
align the Ice/Water Dispenser.
^
Loosen the screws of the four metal
strips.
^ Insert a screwdriver into one of the
four slots and push sideways until the
dispenser is aligned with the custom
door (the gray arrow will adjust to the
rear; the black arrow will adjust front).
^ Re-tighten the screws of the strips.
^ Insert the drip tray back into place,
then clip the water sensors back into
the position.
^
Replace the rear cover, panel and
screw.
^
Replace the drip tray and cover.
^
Finish by putting the plastic grill,
cover, and dispenser back into
place.
Installing the appliance
80