Operating and Installation instructions

Selecting additional settings
84
Switching on the Water Filter Display

If the Water Filter Display has been
switched off once, it must be switched
on again if required.
 In Settings mode , use the  and
 sensor controls to select the Water
Filter Display and select OK to confirm
your selection.
 Use the  and  sensor controls to
select On and select OK to confirm
your selection.
The Water Filter Display has been
switched on.
Switching off the Water Filter Display

 Risk to health due to contami-
nated water.
If the IntensiveClear 2.0 charcoal fil-
ter is not replaced on a regular basis,
it may become contaminated.
Only switch off the Water Filter Display
if an external water filter has been at-
tached to your household water sup-
ply in place of the IntensiveClear 2.0
charcoal filter. In this case, you
should also use an IntensiveClear 2.0
mesh filter in place of the Intensive-
Clear 2.0 charcoal filter (see “Acces-
sories – Optional accessories”).
 In Settings mode , use the  and
 sensor controls to select the Water
Filter Display and select OK to confirm
your selection.
 Use the  and  sensor controls to
select Off and select OK to confirm
your selection.
The Water Filter Display has been
switched off.
Resetting the Water Filter Display 
After you have replaced or cleaned the
water filter, you must reset the Water Fil-
ter Display so that it can be displayed
again after 6months.
If you do not reset the display, it ap-
pears again and again.
 In Settings mode , use the  and
 sensor controls to select the Water
Filter Display and select OK to confirm
your selection.
 Use the  and  sensor controls to
select Reset and select OK to confirm
your selection.
The Replace the water filter message dis-
appears from the display.
The Water Filter Display has been acti-
vated for the next time the water filter
requires cleaning or replacing.