Operating and Installation instructions

Operating the Ice/Water dispenser
97
Switching on the Dispenser
Unit
Ice cubes can only be made when the
ice container is completely closed.
 In Settings mode, use the and
sensor controls to select the Dis-
penser Unit and select OK to confirm
your selection.
 Use the and sensor controls to
select On and select OK to confirm
your selection.
 Close the appliance door.
The Ice/Water dispenser is now ready
for operation.
All sensor controls in the Ice/Water-dis-
penser control panel should now be
highlighted in white.
If this is not the case, the system lock
has been activated (the sensor con-
trol will be highlighted in white, see
“Operating the Ice/Water dispenser –
Switching the system lock on/off”).
Once the freezer zone has cooled down
to its set temperature, the ice maker will
fill with water.
As soon as the water is frozen, the ice
cubes drop out of the ice maker into the
ice container.
Ice production is halted automatically
as soon as the ice container is full.
After the Ice/Water dispenser has
been switched on, it can take up to
24hours until the first serving of ice
cubes is ready.
After the appliance door has opened
and closed, it can take several sec-
onds until the Ice/Water dispenser is
ready for operation and the sensor
controls can be selected again.