Operating instructions
Table Of Contents
- Contents
- Guide to the appliance 4
- Caring for the environment 6
- Warning and Safety instructions 7
- How to save energy 14
- Switching on and off 16
- The correct temperature 20
- Alarm 22
- Super freeze 24
- Freezing and storing food 25
- Defrosting 31
- Cleaning and care 32
- Problem solving guide 35
- Noises 38
- After Sales / Guarantee 39
- Electrical connection 40
- Installation 41
- Installing in a side-by-side combination 45
- Changing the door hinging 52
- Aligning the appliance door 61
- Building in the appliance 62
Electrical connection U.K.
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
local and national safety regulations
(BS 7671 in the UK).
The appliance is supplied with a mains
cable and moulded plug ready for
connection to an a.c. single phase
220-240 V 50 Hz supply.
Please ensure that the connection data
quoted on the data plate match the
household mains supply.
Connection should be made via a
suitable switched socket which is easily
accessible. It must not be located
behind the appliance. For extra safety it
is advisable to protect the appliance
with a suitable residual current device
(RCD).
Do not connect the appliance to the
mains electricity supply by an extension
lead. Extension leads do not guarantee
the required safety of the appliance
(e.g. danger of overheating).
This appliance must not be connected
to the inverter of an autonomous power
supply, e.g. a solar power system.
When switching the appliance on, a
surge in power could trigger the safety
cut-out mechanism. This could damage
the electronic unit.
The appliance must not be used with
so-called energy saving devices. These
reduce the energy supply to the
appliance which could then become
too warm. Using such devices could
alter the specification of the product.
If the connection cable has to be
replaced, this must be done by a
suitably qualified and competent
person.
Do not plug other appliances in behind
this appliance
Non-rewireable plugs (BS 1363)
The fuse cover must be re-fitted when
changing the fuse, and if the fuse cover
is lost, the plug must not be used until a
suitable replacement is obtained. The
colour of the correct replacement cover
is that of the coloured insert in the base
of the plug, or the colour that is
embossed in words in the base of the
plug (as applicable to the design of the
plug fitted).
Replacement fuses should be ASTA
approved to BS 1362 and have the
correct rating. Replacement fuses and
fuse covers may be purchased from
your local electrical supplier.
WARNING
THIS APPLIANCE MUST BE
EARTHED
Electrical connection
40