Operating instructions

Installation steps at the front of the
appliances
^
Screw in middle feet c completely.
They must not come in contact with
the floor.
^ Align the joined appliances using
outer feet b.
Adjust the feet (see also "Installation -
aligning the appliance"):
– at the front:
Align the feet using spanner r
supplied.
–
at the back:
Use a screwdriver to align the feet
with the adjusting device.
Turn the adjusting device clockwise
to raise the appliance up at the back.
^
Position the front of the long stainless
steel trim l in the gap, making sure
that it is located above the
connecting panel g.
Pressing both ridges along the trim
together as you do so makes it
easier to fit the trim into the gap.
^ Carefully work stainless steel trim l
into the gap. Use a soft cloth to do
this to avoid denting the trim.
^ Carefully remove the protective foil
from the stainless steel trim.
Installing in a side-by-side combination
49