Operating instructions

Changing over the hinge brackets
Important! The height of the door
on stainless steel appliances can
be adjusted.
Please read the relevant
instructions.
The instructions are the same for
all appliances from "Fitting the
appliance door".
A. White appliances
(door not height adjustable)
^
Pull hinge pin a together with disc b
and adjustable foot c upwards and
off.
^
Remove cover cap d.
^
Undo screws e and take hinge plate
f off.
^
Unscrew part i from hinge plate f,
rotate it by 180° and refit into the hole
on the opposite side of the hinge
plate.
^
Refit cover cap d in the other hole.
^
Remove cover g.
^
Unscrew and remove screw h and
refit it into the outer hole of the
opposite side.
^
Rotate cover g by 180°, and fit it into
the holes on the other side.
^
Screw hinge plate f into position on
the opposite side using the two outer
long slots only. To make it possible to
align the door later, do not replace
the centre screw at this stage.
^
Important. Screw the adjustable foot
c into hinge pin a as far as it will go.
^
Refit hinge pin a together with disc
b and adjustable foot c. Important.
The notch at the bottom of the hinge
pin should face towards the back.
B. Stainless steel appliances
(height adjustable door)
^
Unscrew threaded pin d by one turn
using the allen key supplied.
^
Pull hinge pin a together with disc b
and adjustable foot c upwards and
off.
^
Remove cover cap e.
^
Undo screws f and take hinge plate
g off.
^
Refit cover cap d
in the other hole.
Changing the door hinging
56