Operating instructions
Table Of Contents
- Contents
- Guide to the appliance 4
- Caring for the environment 6
- Warning and Safety instructions 7
- How to save energy 14
- Switching on and off 16
- The correct temperature 20
- Alarm 22
- Super freeze 24
- Freezing and storing food 25
- Defrosting 31
- Cleaning and care 32
- Problem solving guide 35
- Noises 38
- After Sales / Guarantee 39
- Electrical connection 40
- Installation 41
- Installing in a side-by-side combination 45
- Changing the door hinging 52
- Aligning the appliance door 61
- Building in the appliance 62
^
Unscrew part i from hinge plate g,
rotate it by 180° and refit into the hole
on the opposite side of the hinge
plate.
^
Refit cover cap e in the other hole.
^
Unscrew threaded pin d fully using
the allen key supplied.
^
Fit the threaded pin d into hinge
plate on the opposite side, until it is
flush with the hinge plate.
^
The end must protrude sufficiently
through the hinge pin hole such that
the guide on the hinge pin will fit over
it later on (see following illustration).
^ Remove cover h.
^ Unscrew and remove screw i and
refit it into the outer hole of the
opposite side.
^ Rotate cover h by 180°, and fit it into
the holes on the other side.
^
Screw hinge plate g into position on
the opposite side using the two outer
long slots only. To make it possible to
align the door later, do not replace
the centre screw at this stage.
^
Important. Screw the adjustable foot
c into hinge pin a as far as it will go.
^ Refit the hinge pin a together with
disc b and adjustable foot c such
that the guide on the end of the pin
fits over the threaded pin. Then
tighten it.
^
Then tighten threaded pin d.
Changing the door hinging
57