Operating instructions/Installation instructions

Installation
*INSTALLATION*
53
Changing the upper hinge plate over
 Unscrew hinge pin with the span-
ner supplied.
 Use a flat blade screwdriver to re-
move covers .
 Fit the upper hinge pin to the op-
posite side using the spanner sup-
plied.
 Replace covers on their opposite
sides. Fit them at the back and then
slide them forwards to engage in po-
sition.
 Remover stopper from the door
bearing bush in the appliance door
and replace it on the opposite side.
Changing over the spring clip and the
hinge pin
 Using a screwdriver, remove the
spring clip  from the bottom of the
door and fit it on the opposite side.
 Remove hinge pin together with its
washer .
Important! The gap in the washer
must fit over the stub on hinge pin
so that the washer sits correctly
above the washer on the hinge pin.
 Fit the hinge pin together with
washer in the door bearing bush
on the opposite side. Important! The
stub must point to the inside of the
appliance door and the gap to the
outside.