Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using Super freeze
- Temperature and door alarm
- Selecting further settings
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the door seal
- Cleaning the compressor and metal grille at the back of the appliance
- Starting up the appliance after cleaning
- Problem solving guide
- Noises
- Service
- Installation
Selecting further settings
26
Settings mode
Certain settings on the appliance can
only be selected in settings mode.
To adjust the brightness of the
display
Activating or deactivating the
lock
Settings mode is indicated by the menu
symbol in the display.
The procedure for accessing settings
mode and for changing settings is de-
scribed below.
To adjust the brightness of the dis-
play
The display brightness can be adjusted
to suit lighting conditions in the room.
The brightness of the display can be
altered in 5 stages. The factory default
setting is level 1.
Press the SuperFreeze button for
approx. 5seconds.
The menu symbol lights up. Settings
mode is now active. The lock symbol
flashes.
Press the button for setting the tem-
perature to access the display
brightness function.
The lock symbol goes out and the
display brightness symbol will start
flashing.
Press the SuperFreeze button
briefly to confirm your choice.
The brightness symbol lights up.
Press the button for setting the tem-
perature repeatedly until the bright-
ness level you want is reached.
The more fields that are lit up in the
temperature display, the brighter the
display.
Press the SuperFreeze button
briefly to confirm your choice.
The brightness symbol flashes. The
selected setting is now applied.
To quit settings mode:
Press the On/Off control.
or
Wait 5minutes.
The menu symbol and the bright-
ness symbol go out. The required
temperature appears in the display.