Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using Super freeze
- Temperature and door alarm
- Selecting further settings
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the door seal
- Cleaning the compressor and metal grille at the back of the appliance
- Starting up the appliance after cleaning
- Problem solving guide
- Noises
- Service
- Installation
Installation
*INSTALLATION*
49
Fitting wall spacers supplied
The wall spacers supplied must be
used in order to achieve declared en-
ergy consumption values and to pre-
vent the build-up of condensation at
high ambient temperatures. Appliance
depth is increased by approx. 35mm
with the wall spacers fitted. If the wall
spacers are not used the functionality
of the appliance is not affected. En-
ergy consumption is only slightly in-
creased with less distance between
the appliance and the wall.
Fit the wall spacers onto the back of
the appliance on the top left and
right.
Installing the refrigeration appliance
Danger of injury and damage
due to the refrigeration appliance tip-
ping over.
There is an increased danger of in-
jury and damage if the refrigeration
appliance is installed by a single per-
son.
Two people are required for installing
the refrigeration appliance.
Risk of damaging the floor.
Moving the refrigeration appliance
can cause damage to the floor.
Move the refrigeration appliance
carefully on floors that are sensitive
to scratching.
For easier installation, there are trans-
port handles on the back at the top
and transport wheels underneath the
refrigeration appliance.
Tip: The refrigeration appliance must be
empty when it is installed.
Prepare the refrigeration appliance for
installation as close as possible to its
intended installation location.
Release the mains cable from the
back of the appliance.
Remove the cable clip from the back
of the appliance first.
Move the refrigeration appliance
carefully to its intended installation
location.
Position the refrigeration appliance
with the wall spacers (if used) or the
back close to the wall.