Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using Super freeze
- Temperature and door alarm
- Selecting further settings
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the door seal
- Cleaning the compressor and metal grille at the back of the appliance
- Starting up the appliance after cleaning
- Problem solving guide
- Noises
- Service
- Installation
Installation
*INSTALLATION*
55
If the hinge components (hinge
plate and hinge pin) are not screwed
in tightly enough, the door can fall off
or may not close properly. Cooling
will be less efficient, and condensate
will build up in the interior and this
can cause a build-up of ice.
Screw the hinge plate and the hinge
pin in securely.
Check all screws and tighten if ne-
cessary.
Changing the lower hinge plate over
Undo the screws and remove the
hinge plate .
Slightly loosen the screw in hinge
part on hinge plate. Screw it
into the opposite hole in hinge
plate and then tighten the screws.
Remove stopper and fit it in the
opposite hole in the hinge plate.
Remove cover .
Take screw out and screw it into
the outside hole on the opposite side.
Turn cover through 180° and refit it
on the opposite side.
Screw hinge plate onto the oppos-
ite side, using only the outer two
slots. Do not use the screw in the
middle hole because you will not be
able to align the door later on with the
outer slots.