Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using Super freeze
- Temperature and door alarm
- Selecting further settings
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the door seal
- Cleaning the compressor and metal grille at the back of the appliance
- Starting up the appliance after cleaning
- Problem solving guide
- Noises
- Service
- Installation
Installation
*INSTALLATION*
56
Changing the upper hinge plate over
Unscrew hinge pin with the span-
ner supplied.
Use a flat blade screwdriver to re-
move covers .
Fit the upper hinge pin to the op-
posite side using the spanner sup-
plied.
Replace covers on their opposite
sides. Fit them at the back and then
slide them forwards to engage in po-
sition.
Remover stopper from the door
bearing bush in the appliance door
and replace it on the opposite side.
Changing over the spring clip and the
hinge pin
Using a screwdriver, remove the
spring clip from the bottom of the
door and fit it on the opposite side.
Remove hinge pin together with its
washer .
Important! The gap in the washer
must fit over the stub on hinge pin
so that the washer sits correctly
above the washer on the hinge pin.
Fit the hinge pin together with
washer in the door bearing bush
on the opposite side. Important! The
stub must point to the inside of the
appliance door and the gap to the
outside.