Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching on and off
- The correct temperature
- Using Super freeze
- Temperature and door alarm
- Selecting further settings
- Freezing and storing food
- Maximum freezing capacity
- Freezing fresh food
- Storing frozen food
- Home freezing
- Hints on home freezing
- Packaging food for freezing
- Before placing food in the appliance
- Placing frozen food in the freezer
- – Freezing small amounts of food
- – Freezing the maximum amount of food (see data plate)
- _
- Removing the drawers and glass shelves
- Freezer tray
- Storage time for frozen food
- Defrosting frozen goods
- Cooling drinks quickly
- Using accessories
- Defrosting
- Cleaning and care
- Problem solving guide
- Noises
- Service
- Installation
Problem solving guide
45
Other problems
Problem Cause and remedy
Food has frozen to-
gether.
The food packaging was not dry when placed in the
freezer.
Use a blunt instrument, e.g. a spoon handle or
plastic scraper, to prise it apart carefully.
The door to the freezer
will not open because it
has been opened and
closed too many times
in succession.
This is not a fault. The suction caused by opening
and closing the door is preventing the door from
opening. Wait approx. 1minute and then try again.
It should now open without force.
A buzzer is sounding. The door alarm has been activated.
Close the appliance door. The buzzer will stop.
An LED indicator light is
flashing at the back of
the refrigeration appli-
ance at the bottom near
the compressor (de-
pending on model).
The electronic unit for
the compressor is
equipped with an oper-
ation and fault dia-
gnosis LED indicator
light.
The indicator light flashes several times every
5seconds.
A fault has occurred.
Call the Miele Customer Service Department.
The indicator light flashes regularly every
15seconds.
Not a fault. This flashing is normal.
The external walls of
the appliance feel
warm.
This is not a fault. The heat created by the evapor-
ator is used to prevent condensation.
The door seal is dam-
aged or needs to be re-
placed.
No tools are required to change the door seal.
Change the door seal. A replacement is available
from Miele or from specialist retailers.