Operating instructions/Installation instructions

The correct temperature
21
Setting the temperature
The two sensors next to the display are
used for setting the temperature.
 Touch this sensor to lower the tem-
perature.
 Touch this sensor to increase the
temperature.
The temperature being set will flash in
the display.
The following information can be
viewed in the display when the sensors
are touched:
– Touching a sensor once: the last
temperature selected flashes.
– Each subsequent touch of the
sensor: adjusts the temperature
shown in 1°C steps.
– Leaving a finger on the sensor
changes the temperature continu-
ously.
Approximately 5 seconds after the last
time a sensor has been touched, the
current temperature inside the appli-
ance is automatically shown.
Tip: If you have adjusted the temperat-
ure, wait for approx. 6 hours if the ap-
pliance is not very full and for approx.
24 hours if the appliance is full before
checking the temperature display, as it
will take this long for the appliance to
give an accurate reading. If, after this
time, the temperature is still too high or
too low you will need to reset it.
Temperature range
The temperature can be adjusted from
-14°C to -28°C.
The ambient room temperature and the
installation location can affect the time
it takes for the appliance to reach the
coldest temperature. If the room tem-
perature is too high, the appliance may
not be able to reach the lowest temper-
ature.