Operating instructions

General problems
Problem Possible cause Remedy
The time display is
dark.
The time display has
switched off
automatically to save
energy (Standby mode).
Press any button (except for
the on/off button) to come
out of Standby mode. The
display will light up again.
The Salt indicator light
starts flashing
The salt reservoir has not
been closed properly.
Close the flap to the salt
reservoir properly.
The dishwasher stops.
The Salt indicator
starts flashing.
The Wash/Rinse,
Drying and End
indicators flash at the
same time.
Fault code F86 shows
in the display.
The salt reservoir has not
been closed properly.
–
Switch the dishwasher off
with the On/Off button K.
–
Close the flap to the salt
reservoir properly.
– Start the programme
again.
Problem solving guide
50