Operation Manual

Before using the appliance for
the first time you require:
–
Approx. 1 kg dishwasher salt*,
–
Domestic dishwasher detergent*,
–
Rinse aid* formulated for domestic
dishwashers.
* In the UK, Miele branded products
are available from the Miele Spare
Parts Department or via the internet
on www.miele.co.uk.
Every dishwasher is tested at the
factory.
There will be residual water in the
appliance from this test. It is not an
indication that it has been used
previously.
This dishwasher is fitted with a water
softener sensor which automatically
sets the water softener unit for the
local water hardness level.
To call up the water hardness
level in the display
After your dishwasher has been
through one programme cycle, you can
check the water hardness level
measured by the water softener sensor
in the display.
This is shown in °d - German scale, and
can fluctuate depending on the quality
of the water.
^
Switch the dishwasher off with the Off
button o.
^
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on with the On
button g.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^
Press the Turbo/Combi tabs button
six times.
The Turbo/Combi tabs indicator will
flash six times briefly at intervals.
The number after the p in the display is
the water hardness level in °d (see
chart).
^
Switch the dishwasher off with the Off
button o.
Before using for the first time
14