Operating instructions

Start the programme
^
Select the
Start option.
The message
Please close the door
will appear.
If you want to select a different
programme or make other changes,
select
Back and cancel the programme
with the
Cancel function.
^
Close the door.
The In-operation indicator lights up.The
programme starts.
If you open the door
Add-an-item will
appear in the display.
As long as this prompt is showing,
crockery can be added without
compromising the wash results.
A programme can only be cancelled
in the first few minutes. Otherwise
the programme must continue to the
end so that important programme
stages (e.g. reactivating the water
softener) are not omitted.
Display
The duration of the programme
selected appears in hours and minutes
in the display before the programme
begins. During the programme, the
time left until the end of the programme
is displayed.
The time displayed may vary with the
same programme. This is partly
because of the water temperature at
each intake, the reactivation cycle and
partly because of the amount of
crockery and how dirty it is.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the Programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit takes the new conditions
into account, and calculates the time
required.
To save energy the display goes out
after 10 minutes if you do not touch
any sensors during this time.
Touching any sensor will switch the
display back on again (except for the
button V).
Operation
38