Dishwasher User Manual
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS 4
- Guide to the dishwasher 7
- Caring for the environment 9
- Before using for the first time 10
- Loading the dishwasher 14
- Optional accessories 25
- Use 26
- Additional options 33
- Frequently asked questions 39
- After sales service 46
- User Maintenance Instructions 47
- Cleaning and Care 48
- Installation instructions 53
- Electrical connection 54
- Plumbing 56
- Noise measurement 58
Time display
Before the program starts, the time
display shows the runtime of the
selected program in hours and minutes.
The remaining time is displayed during
the program.
The time that is displayed may vary for
the same program. It depends on the
temperature of the incoming water, the
reactivation cycle, the type of detergent
and the quantity and soiling of the
dishes.
When a program is selected for the first
time, the display shows an average
program runtime for cold water.
With every program, the electronics
correct the runtime according to the
temperature of the incoming water and
the size of the load.
Standby
A few minutes after the last button is
pressed or a few minutes after the end
of the program the dishwasher will
switch to Standby mode to save
energy. The time display and the
indicator lights are turned off and only
the Start/Stop indicator light flashes
slowly.
^ Press the K button if you want to turn
the indicator lights back on.
If the dishwasher is not turned off or
opened after the program ends, after a
few minutes in Standby mode it will turn
off completely (see "Additional options -
Optimize Standby").
If refill rinse aid or a fault is
displayed while a program is
running, the dishwasher will not
switch to Standby mode.
If you use a Tab detergent, you can
deactivate the refill message and let
the dishwasher go into Standby
mode anyway.
However, fault messages cannot be
turned off.
Use
30