Operating instructions

Factory default settings
If you have altered any settings from
the factory default, you can reset them
back to the factory default settings as
follows:
^
Open the door.
^
Switch the dishwasher off with the Off
button V.
^
Press the programme selector button
in and, whilst holding it in, switch
the dishwasher on using the On
button U.
Keep the programme selector button
pressed in for at least four seconds
until the lower-right hand indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the programme selector button
briefly 12 times.
The "Inlet/Drain" indicator light will give
one long flash and two brief flashes at
intervals.
The upper right-hand indicator shows
whether a setting other than the factory
default setting has been set.
–
If the upper right-hand indicator is
flashing:
All settings are factory default
settings.
–
If the upper right-hand indicator is
not lit up:
At least one setting has been altered
from the factory default setting.
^
If you want to reset the factory default
settings, press the programme
selector button for at least one
second until the "Inlet/Drain" indicator
light comes on.
^ Press the programme selector button
briefly.
The setting is now stored in memory.
^ Switch the dishwasher off with the Off
button V.
Additional options
36