Operation Manual

Programme options
51
Buzzer tones
A sequence of audible tones will sound
at the end of the programme or if there
is a fault.
The buzzer at the end of a programme
and the warning buzzer in the event of a
fault will sound 4 times at intervals with
a short pause between each set.
The buzzer tones are activated ex-
works.
You can deactivate the buzzer that
sounds at the end of a programme if
you wish. The warning buzzer for faults
cannot be deactivated.
 Open the door.
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the programme selector button
 in, and whilst holding it in switch
the dishwasher on using the  but‐
ton.
Keep the programme selector button
 pressed in for at least four sec‐
onds until the lower right hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
dure from the beginning again.
 Press the  button 4 times.
The  indicator will flash rapidly 4
times at intervals.
The flashing sequence in the display
shows whether the buzzer at the end of
the programme is activated or deactiva‐
ted.
–  : Buzzer tones activated
–  : Buzzer tones deactivated
 Press the programme selector button
 to change the setting.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.