Operation Manual
Table Of Contents
- Contents
- Guide to the appliance 5
- Warning and Safety instructions 7
- Caring for our environment 12
- Before using for the first time 14
- To open the door 14
- To close the door 14
- Safety lock 14
- Water softener 15
- To call up the water hardness level in the display 17
- Before using the appliance for the first time, you require: 18
- Filling the salt reservoir 18
- Salt indicator 19
- Rinse aid 21
- Adding rinse aid 21
- Rinse aid indicator 22
- Setting the rinse aid dosage 23
- Loading the dishwasher 24
- Operation 33
- Additional functions 39
- Cleaning and care 46
- Problem solving guide 51
- Maintenance 59
- After sales service 61
- Programme chart 62
- Optional accessories 66
- Electrical connection 67
- Plumbing 68
- Technical data 70
Water softener
In order to achieve good cleaning
results, the dishwasher needs to
operate with soft water. Hard water
results in the build-up of calcium
deposits on crockery and in the
dishwasher.
Mains water with a hardness level
higher than 0.7 mmol/l (4 °d – German
scale) needs to be softened. This takes
place automatically in the integrated
water softener. The water softener in
this dishwasher is suitable for a water
hardness level of up to 12.6 mmol/l
(70 °d - German scale).
– The water softener requires
dishwasher salt.
Depending on the water hardness
level (ß 3.8 mmol/l, or 21 °d),
dishwasher salt is not required if
combination tablets are being used
(see "Detergent").
– The dishwasher must be
programmed for the water hardness
in your area.
–
Your local water authority will be able
to advise you of the water hardness
level in your area.
Where the water hardness fluctuates
e.g. between 6.7 - 9.0 mmol/l
(37 - 50 °d) always programme the
dishwasher to the higher value
(9.0 mmol/l in this example).
In the event of a fault, it will help the
service technician if you know the
hardness of your local water supply.
^
Enter the water hardness below:
mmol/l or °d
The dishwasher is programmed at
the factory for a water hardness level
of 2.7 mmol/l (15 °d - German scale).
If this setting corresponds to the
hardness of your water, you do not
need to do anything more.
If your water is harder or softer, you will
need to programme the water hardness
level. See following section.
Before using for the first time
15