Operation Manual
Table Of Contents
- Contents
- Guide to the appliance 5
- Warning and Safety instructions 7
- Caring for our environment 12
- Before using for the first time 14
- To open the door 14
- To close the door 14
- Safety lock 14
- Water softener 15
- To call up the water hardness level in the display 17
- Before using the appliance for the first time, you require: 18
- Filling the salt reservoir 18
- Salt indicator 19
- Rinse aid 21
- Adding rinse aid 21
- Rinse aid indicator 22
- Setting the rinse aid dosage 23
- Loading the dishwasher 24
- Operation 33
- Additional functions 39
- Cleaning and care 46
- Problem solving guide 51
- Maintenance 59
- After sales service 61
- Programme chart 62
- Optional accessories 66
- Electrical connection 67
- Plumbing 68
- Technical data 70
Switching off the refill indicators
If you only ever use combination
products containing salt and rinse aid
in your dishwasher, you can disable
both of these indicators off if you wish.
^
Switch the dishwasher off using the
On/Off K button.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
until the Start/Stop indicator light
comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button 9 times.
The "Delay start" indicator will flash
briefly 9 times at intervals.
The characters flashing in the display
will show whether the refill indicators
are switched on or off.
–
"p1": the refill indicators are switched
on.
–
"p0": the refill indicators are
switched off.
^
If you want to change the setting,
press the Start/Stop button.
The setting is now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
If you switch to using detergent that
does not contain salt or rinse aid, it
is important to remember to
replenish the salt and rinse aid and
to switch the refill indicators back
on.
Before using for the first time
20