Operation Manual
Table Of Contents
- Contents
- Guide to the appliance 5
- Warning and Safety instructions 7
- Caring for our environment 12
- Before using for the first time 14
- To open the door 14
- To close the door 14
- Safety lock 14
- Water softener 15
- To call up the water hardness level in the display 17
- Before using the appliance for the first time, you require: 18
- Filling the salt reservoir 18
- Salt indicator 19
- Rinse aid 21
- Adding rinse aid 21
- Rinse aid indicator 22
- Setting the rinse aid dosage 23
- Loading the dishwasher 24
- Operation 33
- Additional functions 39
- Cleaning and care 46
- Problem solving guide 51
- Maintenance 59
- After sales service 61
- Programme chart 62
- Optional accessories 66
- Electrical connection 67
- Plumbing 68
- Technical data 70
Display
The duration of the programme
selected appears in hours and minutes
in the display before the programme
begins. During the programme, the
time left until the end of the programme
is displayed.
The time displayed may vary with the
same programme. This can be due,
among other factors, to the water
temperature at each intake, the
reactivation process, the type of
detergent, the amount of crockery and
how dirty it is.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
The times shown in the Programme
chart refer to standard test loads and
temperatures.
Each time a programme is run, the
electronic unit takes the new conditions
into account, and calculates the time
required.
Standby
To save energy, the dishwasher will
switch to Standby mode a few minutes
after the last time a button has been
pressed or a few minutes after the end
of the programme. The indicator lights
and the display will go out and only the
Start/Stop indicator will flash slowly.
^
Press the On/Off button K to switch
the indicators and display back on
again.
If the dishwasher is not switched off at
the end of the programme and the door
is not opened, it will switch off
completely after a few minutes in
Standby mode (see "Additional
functions, Optimise standby").
The dishwasher will not switch into
Standby mode whilst a programme
is running, if salt or rinse aid needs
to be replenished or there is a fault.
If you only use combination
products containing salt and rinse
aid in your dishwasher, you can
switch the refill indicators off so that
the dishwasher will go into Standby
despite a lack of salt or rinse aid.
You cannot switch off fault
indicators.
Operation
36