Operation Manual
Table Of Contents
- Contents
- Guide to the appliance 5
- Warning and Safety instructions 7
- Caring for our environment 12
- Before using for the first time 14
- To open the door 14
- To close the door 14
- Safety lock 14
- Water softener 15
- To call up the water hardness level in the display 17
- Before using the appliance for the first time, you require: 18
- Filling the salt reservoir 18
- Salt indicator 19
- Rinse aid 21
- Adding rinse aid 21
- Rinse aid indicator 22
- Setting the rinse aid dosage 23
- Loading the dishwasher 24
- Operation 33
- Additional functions 39
- Cleaning and care 46
- Problem solving guide 51
- Maintenance 59
- After sales service 61
- Programme chart 62
- Optional accessories 66
- Electrical connection 67
- Plumbing 68
- Technical data 70
Adjust Sensor wash
You can adjust the Sensor wash
programme so that it will remove
stubborn soiling in a lightly soiled load.
^
Switch the dishwasher off using the
On/Off button K.
^
Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
until the Start/Stop indicator light
comes on.
If this does not happen, start the
procedure again from the beginning.
^ Press the Delay start button five
times.
The Delay start indicator will flash
briefly five times at intervals.
The flashing sequence in the display
shows what the current setting is.
–
"p1": The Adjust Sensor wash
function is activated.
–
"p0": The Adjust Sensor wash
function is deactivated.
^
If you want to change the setting,
press the Start/Stop button.
The setting is now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
Additional functions
42